TCM REMOVAL

Note

If automatic transmission parts are replaced, refer to Parts Replacement Compensation Table to determine if any additional operations are necessary Click here.


  1. PRECAUTION (w/ Navigation System for HDD)

    Note

    After the engine switch is turned off, the display and navigation module display (HDD navigation system) records various types of memory and settings. As a result, after turning the engine switch off, make sure to wait for the time specified in the following table before disconnecting the cable from the negative (-) battery terminal.

    Waiting Time before Disconnecting Cable from Negative (-) Battery Terminal
    Specification Waiting Time
    w/o Telematics transceiver 60 sec.
    w/ Telematics transceiver 120 sec.

  2. REMOVE ENGINE ROOM SIDE COVER


    1. A019LQM

      Remove the 4 clips.

    2. Disengage the guide and remove the engine room side cover.

  3. REMOVE ENGINE ROOM SIDE COVER LH


    1. A019K5V

      Remove the 4 clips.

    2. Disengage the guide and remove the engine room side cover LH.

  4. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A019MCL

      Remove the 6 clips and cool air intake duct seal.

  5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. REMOVE INLET NO. 2 AIR CLEANER


    1. A019O60

      Disconnect the 2 vacuum hose clamps from the No. 2 air cleaner inlet.

    2. Remove the 2 bolts and No. 2 air cleaner inlet.

  7. REMOVE INLET NO. 1 AIR CLEANER


    1. A019ND6

      Disconnect the vacuum hose clamp from the No. 1 air cleaner inlet.

    2. Remove the bolt and No. 1 air cleaner inlet.

  8. REMOVE BATTERY


    1. Disconnect the positive (+) cable from the positive (+) battery terminal.

    2. A019LTJ

      Loosen the nut, and remove the bolt from the battery clamp.

    3. Remove the battery and battery tray.

  9. REMOVE AIR CLEANER BRACKET


    1. A019OT5

      Remove the 3 bolts and air cleaner bracket.

  10. REMOVE TCM


    1. A019OMH

      Turn the lock lever and disconnect the connector from the TCM.

    2. A019L2N

      Remove the 2 bolts and TCM from the transaxle.