SHIFT PADDLE SWITCH INSPECTION


  1. INSPECT TRANSMISSION SHIFT SWITCH ASSEMBLY


    1. Disconnect the No. 1 switch wire connector from the transmission shift switch assembly.

    2. A019L9ZE02
      Text in Illustration
      *a

      Component without harness connected

      (Transmission Shift Switch Assembly)
      *b for LH ("-")
      *c for RH ("+")

      Measure the resistance between each terminal when the transmission shift switch assembly is moved to each position.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      1 (SFTD) - 2 (ECC)

      Pull "-" continuously

      (Down shift)

      		 Below 1 Ω
      Release 10 kΩ or higher
      2 (ECC1) - 3(SFTU)

      Pull "+" continuously

      (Up shift)

      		 Below 1 Ω
      Release 10 kΩ or higher

      If the resistance value is not as specified, replace the transmission shift switch assembly.