ENGINE SWITCH INSTALLATION


  1. INSTALL ENGINE SWITCH


    1. A019PBB

      Connect the engine switch connector.

    2. A019LBJ

      Attach the 2 claws to install the engine switch.

  2. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY


    1. Connect each connector.

    2. Engage the 8 clips and 2 guides.

    3. Install the lower instrument panel finish panel sub-assembly with the 2 screws <D>.

    4. A019NKJ

      Engage the 2 claws to close the cover as shown in the illustration.

  3. INSTALL NO. 1 SWITCH HOLE BASE


    1. Connect each connector.

    2. A019N7C

      Engage the 4 claws and 2 guides to install the No. 1 switch hole base.

  4. INSTALL INSTRUMENT PANEL GARNISH LH (for LHD)


    1. A019K28

      Engage the 6 clips to install the instrument panel garnish LH.

  5. INSTALL INSTRUMENT PANEL GARNISH RH (for RHD)

    Tech Tips


  6. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH (for LHD)


    1. A019L27

      Engage the 2 clips to install the cowl side trim sub-assembly LH.

    2. Install the clip.

  7. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH (for RHD)

    Tech Tips

    Use the same procedure for the RH side and the LH side.

  8. INSTALL FRONT DOOR SCUFF PLATE LH (for LHD)


    1. w/ Illumination:


      1. Connect the connector.

    2. A019LA0

      Engage the 4 clips, guide and 7 claws, and install the front door scuff plate LH.

  9. INSTALL FRONT DOOR SCUFF PLATE RH (for RHD)

    Tech Tips

    Use the same procedure for the RH side and the LH side.

  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.