LUBRICATION SYSTEM ON-VEHICLE INSPECTION


  1. INSPECT ENGINE OIL LEVEL


    1. Warm up and stop the engine, then wait for 5 minutes.

    2. Check that the oil level is between the low level and full level marks on the level dipstick.

      If the level is low, check for leakage and add oil up to the full level mark.

      Note

      Do not fill the engine with oil to above the full level mark.

  2. INSPECT ENGINE OIL QUALITY


    1. Check the oil for deterioration, water contamination, discoloration or thinning. If the quality is visibly poor, replace the oil and filter.

  3. INSPECT OIL PRESSURE


    1. Remove the oil pressure switch assembly Click here.

    2. A019PFOE02
      Text in Illustration
      *1 Oil Pressure Gauge

      Install an oil pressure gauge.

    3. Warm up the engine.

    4. Measure the oil pressure.

      Standard Oil Pressure
      Condition Specified Condition
      Idle

      30 kPa (0.3 kgf/cm2, 4.4 psi) or more
      4000 rpm

      260 kPa (2.7 kgf/cm2, 38 psi) or more

    5. Remove the oil pressure gauge.

    6. Install the oil pressure switch assembly Click here.