OIL LEVEL SENSOR REMOVAL


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before service Click here.

  2. REMOVE FRONT WHEEL RH

  3. REMOVE FRONT FENDER LINER RH

  4. REMOVE FRONT FENDER APRON SEAL RH


    1. A019O37

      Remove the 2 bolts, clip and front fender apron seal RH.

  5. DRAIN ENGINE OIL


    1. Remove the oil filler cap.

    2. Remove the oil pan drain plug and gasket, and drain the oil into a container.

    3. Clean the oil pan drain plug.

    4. Install the oil pan drain plug with a new gasket.

      Torque:
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

  6. REMOVE ENGINE OIL LEVEL SENSOR


    1. A019LUK

      Release the claw and disconnect the wire harness protector.

    2. A019KMP

      Disconnect the oil pressure switch connector.

    3. A019OTI

      Disconnect the engine oil level sensor connector.

    4. A019N1Q

      Remove the 4 bolts, then remove the oil level sensor and gasket.

    5. Remove the gasket from the oil level sensor.