VACUUM SWITCHING VALVE (for ACIS) REMOVAL


  1. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

    Click here

  2. SEPARATE HOSE BRACKET (for LHD)


    1. A019P7C

      Remove the 2 nuts and separate the hose bracket from the outer cowl top panel sub-assembly.

  3. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)


    1. A019O7N

      Disconnect the connector (w/ Windshield Deicer).

    2. Disengage the grommet and clamp, and separate the wire harness.

    3. A019OCL

      Remove the 6 nuts, 4 bolts and outer cowl top panel sub-assembly.

  4. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)


    1. A019N0P

      Disconnect the connector (w/ Windshield Deicer).

    2. Disengage the grommet and clamp, and separate the wire harness.

    3. A019OF3

      Remove the 6 nuts, 4 bolts and outer cowl top panel sub-assembly.

  5. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. A019KNK

      Lift the rear of the No. 1 engine cover sub-assembly to detach the cover from the 2 pins, and then lift the front of the No. 1 engine cover sub-assembly to detach the cover from the pin and remove the No. 1 engine cover sub-assembly.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the No. 1 engine cover sub-assembly to break.

  6. REMOVE VACUUM SWITCHING VALVE ASSEMBLY (for ACIS)


    1. A019OQ5

      Disconnect the union to connector tube hose and wire harness clamp.

    2. Disconnect the 2 vacuum hoses and connector.

    3. Remove the bolt and vacuum switching valve assembly.

    4. A019MAQ

      Remove the bolt and vacuum tube bracket.