CANISTER REMOVAL


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work Click here.

  2. PRECAUTION (w/ Air Suspension)

    Note

    Be sure to read Precaution thoroughly before servicing Click here.

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE TAIL EXHAUST PIPE ASSEMBLY


    1. A019ME8

      Remove the 2 bolts and 2 compression springs.

    2. Remove the tail exhaust pipe assembly from the 4 exhaust pipe supports.

    3. Remove the gasket from the center exhaust pipe assembly.

  5. REMOVE CHARCOAL CANISTER PROTECTOR


    1. A019O16

      Remove the 3 bolts and charcoal canister protector.

  6. REMOVE CHARCOAL CANISTER ASSEMBLY


    1. A019MDVE01

      Pull the retainer up as shown in the illustration.

      Tech Tips

      Perform this work by hand. Do not use any tools.

    2. Disconnect the vent line tube.

    3. Disconnect the purge line hose.

    4. Disconnect the air inlet line hose.

    5. A019PKN

      Remove the 3 nuts, 2 clips and charcoal canister assembly.