Click here

CANISTER REMOVAL

Click here
Click here Click here
  1. Click here

    PRECAUTION

    Note:

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work (Click here).

  2. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  3. Click here

    REMOVE TAIL EXHAUST PIPE ASSEMBLY


    1. A019M7P

      Remove the 2 bolts and 2 compression springs.

    2. Remove the tail exhaust pipe assembly from the 4 exhaust pipe supports.

    3. Remove the gasket from the center exhaust pipe assembly.

  4. Click here

    REMOVE CHARCOAL CANISTER PROTECTOR


    1. A019O16

      Remove the 3 bolts and charcoal canister protector.

  5. Click here

    REMOVE CHARCOAL CANISTER ASSEMBLY


    1. A019MDVE02

      Pull the retainer up as shown in the illustration.

      Table 1. Text in Illustration
      *1 Retainer
      *2 Claw
      *a Pull
      *b Pull out
      Tip:

      Perform this work by hand. Do not use any tools.

    2. Disconnect the vent line tube.

    3. Disconnect the purge line hose.

    4. Disconnect the air inlet line hose.

    5. A019PKN

      Remove the 3 nuts, 2 clips and charcoal canister assembly.