FUEL PUMP REMOVAL


  1. PRECAUTION

    Note

    After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work Click here.

  2. DISCHARGE FUEL SYSTEM PRESSURE

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE REAR SEAT ASSEMBLY LH


    1. Remove the rear seat assembly LH Click here.

  5. REMOVE REAR DOOR SCUFF PLATE LH


    1. A019NH1

      Disengage the 6 claws, 3 clips and guide, and remove the rear door scuff plate LH.

  6. REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH


    1. A019L4W

      Remove the rear door opening trim weatherstrip LH.

  7. REMOVE REAR FLOOR SERVICE HOLE COVER


    1. A019OSY

      Using a clip remover, remove the clip and lift up the front floor carpet.

    2. A019MI6

      Remove the rear floor service hole cover.

    3. Disconnect the fuel pump connector.

  8. REMOVE FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE


    1. A019O2FE02
      Text in Illustration
      *1 Tube Joint Clip
      *2 Nylon Tube
      *3 Fuel Tube Joint
      *4 O-ring
      *5 Fuel Suction Plate
      *6 Tube Joint Clip

      Remove the tube joint clip, and pull out the fuel tank main tube sub-assembly.

      Note


      • Check that there is no dirt or other foreign objects around the connector before disconnecting it. Clean the connector if necessary.

      • It is necessary to prevent mud or dirt from entering the quick connector. If mud or dirt gets in the connector, the O-rings may not seal properly.

      • Disconnect the quick connector by hand. Do not use any tools.

      • Do not bend, kink or twist the nylon tubes. Protect the connector by covering it with a plastic bag.

      • If the pipe and connector are stuck, carefully try wiggling or pushing and pulling on the connector to release it. Pull the connector off carefully.

    2. A019MCUE01

      Using a 6 mm socket hexagon wrench, install SST to the fuel pump gauge retainer.

      SST
      09808-14020   ( 09808-01410, 09808-01420, 09808-01430 )

      Tech Tips


      • Engage the SST claws securely with the fuel pump gauge retainer ribs to secure SST.

      • Install SST while pressing the SST claws toward the fuel pump gauge retainer (toward the center of SST).

    3. A019K1O

      Using SST, loosen the fuel pump gauge retainer.

      SST
      09808-14020   ( 09808-01410, 09808-01420, 09808-01430 )

      Note


      • Do not use any tools other than specified in this operation. Damage to the fuel pump gauge retainer or the fuel tank may result.

      • Loosen the retainer by turning it counterclockwise while holding SST down. Do not allow the claw of the tank suction tube support to slip out of its groove on the fuel tank.

      Tech Tips

      The ribs on the fuel pump gauge retainer can be fitted into the tips of SST.

    4. Remove the fuel pump gauge retainer.

    5. A019MSYE01
      Text in Illustration
      *1 Arm

      Remove the fuel suction tube with pump and gauge.

      Note

      Be careful not to bend the arm of the fuel sender gauge.

    6. Remove the gasket from the fuel tank.