FRONT CRANKSHAFT OIL SEAL INSTALLATION


  1. INSTALL TIMING CHAIN CASE OIL SEAL


    1. A019JV2E02

      Apply MP grease to a new timing chain case oil seal lip.

    2. Using SST and a hammer, tap in the timing chain case oil seal until its surface is flush with the timing chain cover edge.

      SST
      09223-22010
      09506-35010
      Oil seal tap in depth
      0 to 1.0 mm (0 to 0.0393 in.)

      Note


      • Keep the lip free of foreign matter.

      • Do not tap the timing chain case oil seal at an angle.

  2. INSTALL CRANKSHAFT PULLEY


    1. A019KY0

      Align the pulley set key with the key groove of the pulley, and slide on the pulley.

    2. A019N80E01

      Using SST, install the pulley bolt.

      SST
      09213-70011   ( 09213-70020 )
      09330-00021
      Torque:
      250 N*m  { 2550 kgf*cm, 184 ft.*lbf }

  3. INSTALL V-RIBBED BELT


    1. A019OSRE02
      Text in Illustration
      *1 Water Pump
      *2 Idler
      *3 Generator
      *4 Crankshaft
      *5 V-ribbed belt Tensioner
      *6 A/C Compressor

      Install the V-ribbed belt.

    2. A019NA3

      Turn the V-ribbed belt tensioner counterclockwise and remove a 5 mm bi-hexagon wrench.

    3. After installing the V-ribbed belt, check that it fits properly in the ribbed grooves. Confirm that the belt has not slipped out of the grooves on the bottom of the crank pulley by hand.

  4. INSTALL FRONT FENDER APRON SEAL RH


    1. A019O37

      Install the front fender apron seal RH with the 2 bolts and clip.

  5. INSTALL FRONT FENDER LINER RH

  6. INSTALL FRONT WHEEL RH

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }