REAR CRANKSHAFT OIL SEAL INSTALLATION


  1. INSTALL REAR ENGINE OIL SEAL


    1. Apply MP grease to the lip of a new oil seal.

      Note


      • Do not allow foreign matter to contact the lip of the oil seal.

      • Do not allow MP grease to contact the dust seal.

    2. A019JRJE01

      Using SST and a hammer, tap in the oil seal until its surface is flush with the edges of the cylinder block and crankcase.

      SST
      09223-15030
      09950-70010   ( 09951-07150 )

      Note


      • Keep the lip of the oil seal free from foreign matter.

      • Do not tap in the oil seal at an angle.

  2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. A019NX0E02

      Using SST, hold the crankshaft.

      SST
      09213-54015
      09330-00021

      Tech Tips

      SST (Crankshaft pulley holding tool) Fixing bolt part No. : 91551-80650(2 pcs)

    2. Clean the bolts and their installation holes.

    3. A019NMT

      Install the front drive plate spacer.

      Tech Tips

      Align the pin of the front drive plate spacer with the pin hole of the crankshaft.

    4. A019N52E03
      Text in Illustration
      *1 Drive Plate and Ring Gear Sub-assembly
      *2 Rear Drive Plate Spacer
      A019NE4 Transaxle Side

      Install the drive plate and ring gear sub-assembly and rear drive plate spacer to the crankshaft.

    5. A019MWWE03
      Text in Illustration
      *1 Adhesive 1324

      Apply a few drops of adhesive to 2 or 3 threads of the bolt end.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
    6. A019KG1E01

      Install and uniformly tighten the 8 bolts in the sequence shown in the illustration.

      Torque:
      98 N*m  { 999 kgf*cm, 72 ft.*lbf }

      Note


      • Do not strike or damage the drive plate installation bolts. Be sure to handle them carefully.

      • Do not start the engine for at least an hour after installing the drive plate.

  3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY

    Click here