FRONT CRANKSHAFT OIL SEAL INSTALLATION


  1. INSTALL TIMING CHAIN COVER OIL SEAL


    1. Apply MP grease to the lip of a new oil seal.

      Note


      • Do not allow foreign matter to contact the lip of the oil seal.

      • Do not allow MP grease to contact the dust seal.

    2. A019LCPE01

      Using SST and a hammer, tap in the oil seal until its surface is flush with the timing chain cover edge.

      SST
      09223-22010

      Note


      • Keep the lip of the oil seal free from foreign matter.

      • Do not tap in the oil seal at an angle.

  2. INSTALL CRANKSHAFT PULLEY


    1. Align the pulley set key with the key groove of the crankshaft pulley.

    2. A019PA6E01

      Using SST, hold the crankshaft pulley and install the pulley bolt.

      SST
      09213-54015
      09330-00021
      Torque:
      260 N*m  { 2651 kgf*cm, 192 ft.*lbf }

      Tech Tips

      SST (Crankshaft pulley holding tool) Fixing bolt part No. : 91551-80650(2 pcs)

  3. INSTALL V-RIBBED BELT


    1. A019N3FE03
      Text in Illustration
      *1 Generator
      *2 Tensioner
      *3 Crankshaft
      *4 Water Pump
      *5 Cooler Compressor

      Set the V-ribbed belt onto each part as shown in the illustration except the water pump pulley.

    2. Loosen the V-ribbed belt by turning the belt tensioner clockwise.

    3. Set the V-ribbed belt onto the water pump pulley.

      Note

      Make sure that the belt is attached to each pulley. In particular, make sure that the belt is securely fitted into the grooves of the crankshaft pulley.

  4. INSPECT ENGINE OIL LEVEL

  5. INSTALL FRONT FENDER APRON SEAL RH


    1. A019O37

      Install the front fender apron seal RH with the 2 bolts and clip.

  6. INSTALL FRONT FENDER LINER RH

  7. INSTALL FRONT WHEEL RH

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }