DRIVE BELT INSTALLATION


  1. INSTALL V-RIBBED BELT


    1. A019OSRE02
      Text in Illustration
      *1 Water Pump
      *2 Idler
      *3 Generator
      *4 Crankshaft
      *5 V-ribbed belt Tensioner
      *6 A/C Compressor

      Install the V-ribbed belt.

    2. A019NA3

      Turn the V-ribbed belt tensioner counterclockwise and remove a 5 mm bi-hexagon wrench.

    3. After installing the V-ribbed belt, check that it fits properly in the ribbed grooves. Confirm that the belt has not slipped out of the grooves on the bottom of the crank pulley by hand.

  2. INSTALL FRONT FENDER APRON SEAL RH


    1. A019O37

      Install the front fender apron seal RH with the 2 bolts and clip.

  3. INSTALL FRONT FENDER LINER RH

  4. INSTALL FRONT WHEEL RH

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }