DRIVE BELT INSTALLATION


  1. INSTALL V-RIBBED BELT


    1. A019N3FE03
      Text in Illustration
      *1 Generator
      *2 Tensioner
      *3 Crankshaft
      *4 Water Pump
      *5 Cooler Compressor

      Set the V-ribbed belt onto each part as shown in the illustration except the water pump pulley.

    2. Loosen the V-ribbed belt by turning the belt tensioner clockwise.

    3. Set the V-ribbed belt onto the water pump pulley.

      Note

      Make sure that the belt is attached to each pulley. In particular, make sure that the belt is securely fitted into the grooves of the crankshaft pulley.

  2. INSTALL FRONT FENDER APRON SEAL RH


    1. A019O37

      Install the front fender apron seal RH with the 2 bolts and clip.

  3. INSTALL FRONT FENDER LINER RH

  4. INSTALL FRONT WHEEL RH

    Torque:
    103 N*m  { 1050 kgf*cm, 76 ft.*lbf }