SFI SYSTEM PRECAUTION


  1. INITIALIZATION

    Note

    Perform the Registration (VIN registration) when replacing the ECM Click here.

    Tech Tips

    Reset memory or initialization cannot be completed by only disconnecting and reconnecting the cable of the negative (-) battery terminal.

  2. FOR USING INTELLIGENT TESTER

    CAUTION:

    Observe the following items for safety reasons:


    • Read the instruction manual before using the tester.

    • Prevent the tester cable from being caught on the pedals, shift lever or steering wheel when driving with the tester connected to the vehicle.

    • When driving the vehicle for testing purposes using the tester, 2 persons are required. One is for driving the vehicle, and the other operates the tester.

  3. DISCONNECTING AND RECONNECTING NEGATIVE BATTERY CABLE

    A019OKXE03
    Text in Illustration
    *1 Negative (-) Battery Terminal
    *2 Cable

    1. Before performing work on electronic components, disconnect the cable from the negative (-) battery terminal in order to prevent damage to the electrical system or components.

    2. Before disconnecting and reconnecting the battery cable, turn the engine switch off and the headlight switch off. Then loosen the terminal nut completely. Do not damage the cable or terminal.

    3. When the battery cable is disconnected, the clock and radio settings and stored DTCs are cleared. Therefore, before disconnecting the battery cable, make a note of them.

      Note

      When the cable is disconnected from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected.

      System Name See Procedure
      Parking Assist Monitor System (w/ Side Monitor System)

      Click here

      Parking Assist Monitor System (w/o Side Monitor System)
      Side Monitor System
      Back Door Closer System
      Power Back Door System