AIR FUEL RATIO SENSOR REMOVAL


  1. REMOVE ENGINE ROOM SIDE COVER


    1. A019LQM

      Remove the 4 clips.

    2. Disengage the guide and remove the engine room side cover.

  2. REMOVE ENGINE ROOM SIDE COVER LH


    1. A019K5V

      Remove the 4 clips.

    2. Disengage the guide and remove the engine room side cover LH.

  3. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A019MCL

      Remove the 6 clips and cool air intake duct seal.

  4. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. A019KNK

      Lift the rear of the No. 1 engine cover sub-assembly to detach the cover from the 2 pins, and then lift the front of the No. 1 engine cover sub-assembly to detach the cover from the pin and remove the No. 1 engine cover sub-assembly.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the No. 1 engine cover sub-assembly to break.

  5. REMOVE NO. 2 AIR CLEANER INLET


    1. A019MRA

      Remove the 2 bolts and No. 2 air cleaner inlet.

  6. REMOVE AIR FUEL RATIO SENSOR


    1. A019P5H

      Disconnect the air fuel ratio sensor connector.

    2. Remove the wire harness clamp.

    3. A019NST

      Remove the 4 bolts and No. 1 exhaust manifold heat insulator.

    4. A019OF7E01

      Using SST, remove the air fuel ratio sensor from the exhaust manifold.

      SST
      09224-00010