CAMSHAFT POSITION SENSOR INSTALLATION


  1. INSTALL CAMSHAFT POSITION SENSOR


    1. Camshaft position sensor (for intake side)


      1. Clean and degrease the threads of the bolt for the camshaft position sensor.

      2. Apply a light coat of engine oil to the O-ring of the sensor.

        Note

        Make sure that the O-ring is not cracked or does not jump out of position during installation.

      3. A019MWWE06
        Text in Illustration
        *1 Adhesive

        Apply adhesive to 2 or 3 threads of the bolt.

        Adhesive
        Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent.

      4. Install the sensor with the bolt.

        Torque:
        10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      5. Connect the sensor connector.

    2. Camshaft position sensor (for exhaust side)


      1. Clean and degrease the threads of the bolt for the camshaft position sensor.

      2. Apply a light coat of engine oil to the O-ring of the sensor.

        Note

        Make sure that the O-ring is not cracked or does not jump out of position during installation.

      3. A019MWWE06
        Text in Illustration
        *1 Adhesive

        Apply adhesive to 2 or 3 threads of the bolt.

        Adhesive
        Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent.

      4. Install the sensor with the bolt.

        Torque:
        10 N*m  { 102 kgf*cm, 7 ft.*lbf }

      5. Connect the sensor connector.

  2. INSPECT FOR OIL LEAK

  3. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. A019KNK

      Fit the 3 retainers and install the No. 1 engine cover sub-assembly.

  4. INSTALL COOL AIR INTAKE DUCT SEAL


    1. Install the cool air intake duct seal with the 6 clips.

  5. INSTALL ENGINE ROOM SIDE COVER LH


    1. Engage the guide.

    2. Install the engine room side cover LH with the 4 clips.

  6. INSTALL ENGINE ROOM SIDE COVER


    1. Engage the guide.

    2. Install the engine room side cover with the 4 clips.