CAMSHAFT POSITION SENSOR REMOVAL


  1. REMOVE ENGINE ROOM SIDE COVER


    1. A019LQM

      Remove the 4 clips.

    2. Disengage the guide and remove the engine room side cover.

  2. REMOVE ENGINE ROOM SIDE COVER LH


    1. A019K5V

      Remove the 4 clips.

    2. Disengage the guide and remove the engine room side cover LH.

  3. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A019MCL

      Remove the 6 clips and cool air intake duct seal.

  4. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. A019KNK

      Lift the rear of the No. 1 engine cover sub-assembly to detach the cover from the 2 pins, and then lift the front of the No. 1 engine cover sub-assembly to detach the cover from the pin and remove the No. 1 engine cover sub-assembly.

      Note

      Attempting to disengage both front and rear clips at the same time may cause the No. 1 engine cover sub-assembly to break.

  5. REMOVE CAMSHAFT POSITION SENSOR


    1. Camshaft position sensor (for exhaust side)


      1. A019PMK

        Disconnect the sensor connector.

      2. Remove the bolt and sensor.

    2. Camshaft position sensor (for intake side)


      1. A019JT2

        Disconnect the sensor connector.

      2. Remove the bolt and sensor.