BACK DOOR OPENER SWITCH INSTALLATION


  1. INSTALL BACK DOOR OPENER SWITCH ASSEMBLY


    1. A019N7V

      Install the back door opener switch assembly.

  2. INSTALL BACK DOOR OUTSIDE GARNISH SUB-ASSEMBLY


    1. Install 2 bolts.

    2. Install 2 stud bolts.

    3. Install 2 new back door outside garnish clips and 4 new gaskets on the back door outside garnish subassembly.

    4. A019KA8

      Engage the 2 clips to install the back door outside garnish sub-assembly.

    5. Install the 4 nuts.

      Torque:
      4.9 N*m  { 50 kgf*cm, 43 in.*lbf }

    6. Connect each connector.

  3. INSTALL BACK DOOR TRIM PANEL ASSEMBLY


    1. A019LDRE01
      Text in Illustration
      *1 2-piece Type Clip

      Engage the 2 claws and 16 clips to install the back door trim panel assembly.

    2. Install the 2 screws.

  4. INSTALL BACK DOOR SERVICE HOLE COVER LH


    1. A019NI2

      Engage the 5 claws to install the back door service hole cover LH.

  5. INSTALL BACK DOOR SERVICE HOLE COVER RH


    1. A019P9A

      Engage the 5 claws to install the back door service hole cover RH.

  6. INSTALL BACK DOOR UPPER TRIM COVER LH


    1. A019NIZ

      Engage the 2 claws to install the back door upper trim cover LH.

  7. INSTALL BACK DOOR UPPER TRIM COVER RH


    1. A019L37

      Engage the 2 claws to install the back door upper trim cover RH.

  8. INSTALL NO. 2 ROOM LIGHT ASSEMBLY


    1. Connect the connector.

    2. A019KWD

      Engage the claw to install the No. 2 room light assembly.

  9. INSTALL BACK DOOR LOCK COVER


    1. A019M2K

      Engage the 4 claws to install the back door lock cover.

  10. INSTALL BACK DOOR FINISH COVER LH (w/o Power Back Door)


    1. A019OK7

      Engage the 6 claws to install the back door finish cover LH.

  11. INSTALL BACK DOOR TRIM BASE (w/ Power Back Door)


    1. A019N4R

      Engage the 4 claws to install the back door trim base.

  12. INSTALL BACK DOOR FINISH COVER RH (w/o Power Back Door)


    1. A019O6R

      Engage the 6 claws to install the back door finish cover RH.

  13. INSTALL DOOR PULL HANDLE WITH SWITCH (w/ Power Back Door)


    1. Connect the connector.

    2. A019LWL

      Engage the 6 claws to install the door pull handle with switch.

  14. INSTALL TONNEAU COVER SUB-ASSEMBLY