Click here

ROOF SUNSHADE REASSEMBLY

Click here
Click here Click here
  1. Click here

    INSTALL SLIDING ROOF SIDE GARNISH LH


    1. A019L9N

      Install the sliding roof side garnish LH with the 3 screws.

    2. A019OKT

      Connect the outer casing.

  2. Click here

    INSTALL SLIDING ROOF SIDE GARNISH RH

    Tip:

    Use the same procedure for the LH side and RH side.

  3. Click here

    INSTALL SUNSHADE TRIM SUB-ASSEMBLY (for Front)


    1. A019JWW

      Engage the 10 guides to connect the sliding roof drive cable.

      Note:

      Do not bend or break the sliding roof drive cable.

    2. Slide the sunshade trim sub-assembly in the direction indicated by the arrow to install it.

  4. Click here

    INSTALL SUNSHADE TRIM SUB-ASSEMBLY (for Center)


    1. A019JY4

      Engage the 2 claws to install the sunshade trim sub-assembly.

    2. Slide the sunshade trim sub-assembly and insert it to the position shown in the illustration.

  5. Click here

    INSTALL SUNSHADE TRIM SUB-ASSEMBLY (for Rear)


    1. A019MGJ

      Engage the 2 claws to install the sunshade trim sub-assembly.

    2. Slide the sunshade trim sub-assembly and insert it to the position shown in the illustration.

    3. A019KO5

      Using "TORX" socket wrench T20, install the front sliding roof sunshade guide LH with the 2 "TORX" bolts.

      4.0 N*m 41 kgf*cm 35 in.*lbf
      Tip:

      Use the same procedure for the LH side and RH side.

    4. A019NL4

      Using "TORX" socket wrench T20, install the rear sliding roof sunshade guide LH with the 2 "TORX" bolts.

      4.0 N*m 41 kgf*cm 35 in.*lbf
      Tip:

      Use the same procedure for the LH side and RH side.

    5. A019OJ9E01

      Align the front side sunshade trim sub-assembly with the position shown by the stamped mark in the illustration.

      Table 1. Text in Illustration
      *1 Stamped Mark
      Tip:

      Use the same procedure for the LH side and RH side.

  6. Click here

    INSTALL SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY


    1. A019P9F

      Install the sliding roof drive gear sub-assembly and roof light bracket with the 2 bolts.

      5.4 N*m 55 kgf*cm 48 in.*lbf