ROOF SUNSHADE INSTALLATION


  1. INSTALL SLIDING ROOF HOUSING


    1. Temporarily install the sliding roof housing with the 12 nuts.

      A019JSEE01

    2. Tighten the 2 nuts in the order shown in the illustration.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    3. Tighten the 10 nuts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

  2. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY LH

    Tech Tips


    • Use the same procedure for the RH side and LH side.

    • The procedure listed below is for the LH side.


    1. Check that the engine switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Temporarily install the curtain shield airbag assembly with the 10 hooks.

      A019NHA

      Note

      Do not twist the curtain shield airbag assembly when installing it.

    4. Install 10 new bolts.

      Torque:
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }

    5. Connect the curtain shield airbag connector.

      Note

      When connecting the airbag connector, take care not to damage the airbag wire harness.

  3. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY RH

    Tech Tips

    Use the same procedure for the RH side and the LH side.

  4. INSTALL ROOF HEADLINING ASSEMBLY


    1. Install the roof headlining assembly Click here.

  5. INITIALIZE ROOF SUNSHADE ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY)

    Click here