FRONT SEAT OUTER BELT ASSEMBLY INSTALLATION


  1. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    1. Engage the guide to temporarily install the front shoulder belt anchor adjuster assembly with the 2 bolts.

    2. A019KAIE01

      Fully tighten the bolt <A> first, then the bolt <B> to install the front shoulder belt anchor adjuster assembly.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

  2. INSTALL FRONT SEAT OUTER BELT ASSEMBLY


    1. Temporarily install the front seat outer belt assembly with the 2 bolts.

    2. A019LLGE01

      Fully tighten the bolt <A> first, then the bolt <B> to install the front seat outer belt assembly.

      Torque:
      Bolt <A>
      7.5 N*m  { 77 kgf*cm, 66 in.*lbf }
      Bolt <B>
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }
    3. A019NMN

      Connect the connector and lock the locking button as shown in the illustration.

      Note

      Securely lock the locking button.

    4. Connect each connector.

    5. A019LER

      Connect the shoulder anchor of the front seat outer belt assembly with the nut.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

  3. INSTALL CENTER PILLAR GARNISH


    1. Pass the floor anchor of the front seat outer seat belt assembly LH through the center pillar garnish LH.

    2. A019MR0

      Engage the clip to install the center pillar garnish LH with the 2 screws.

  4. CONNECT FRONT SEAT OUTER BELT ASSEMBLY


    1. A019JMI

      Install the floor end of the front seat outer belt assembly with the bolt.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

    2. Check if the ELR locks.

      Note

      The check should be performed with the outer belt assembly installed.


      1. With the belt assembly installed, check that the belt locks when it is pulled out quickly.

  5. INSTALL LOWER CENTER PILLAR GARNISH


    1. A019OBL

      Engage the 2 claws and the 5 clips to install the lower center pillar garnish LH.

  6. INSTALL REAR DOOR SCUFF PLATE


    1. A019NH1

      Engage the 3 clips, guide and 6 claws, and install the rear door scuff plate LH.

  7. INSTALL FRONT DOOR SCUFF PLATE


    1. w/ Illumination:


      1. Connect the connector.

    2. A019LA0

      Engage the 4 clips, guide and 7 claws, and install the front door scuff plate LH.

  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  9. INSPECT SRS WARNING LIGHT


    1. Inspect the SRS warning light Click here.