AIRBAG CUT-OFF SWITCH INSPECTION


  1. INSPECT AIRBAG CUT OFF SWITCH


    1. Turn the engine switch off.

    2. Disconnect the cable from the negative (-) battery terminal.

      Note

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A019M0OE01
      Text in Illustration
      *1

      Component without harness connected

      (Airbag Cut Off Switch)

      Disconnect the connector from the airbag cut off switch.

    4. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      F85-2 (PMC+) - F85-1 (PMC-) Cut off switch is in ON position 360 to 440 Ω
      F85-2 (PMC+) - F85-1 (PMC-) Cut off switch is in OFF position 90 to 110 Ω

      If the result is not as specified, replace the airbag cut off switch.