ПЕРЕКЛЮЧАТЕЛЬ УПРАВЛЕНИЯ ПЕРЕКЛЮЧЕНИЕМ ПРОВЕРКА


  1. INSPECT TRANSMISSION SHIFT SWITCH ASSEMBLY


    1. Disconnect the No. 1 switch wire connector from the transmission shift switch assembly.

    2. A01FRN9E01
      Text in Illustration
      *1 for LH ("-")
      *2 for RH ("+")
      *a

      Component without harness connected

      (Shift Paddle Switch Assembly)

      Measure the resistance between each terminal when the transmission shift switch assembly is moved to each position.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      SDN - ECC

      Pull continuously

      "-"

      (Down shift)

      Below 2.5 Ω
      SDN - ECC

      Release

      "-"

      (Down shift)

      1 MΩ or higher
      SUP - ECC

      Pull continuously

      "+"

      (Up shift)

      Below 2.5 Ω
      SUP - ECC

      Release

      "+"

      (Up shift)

      1 MΩ or higher

      If the resistance value is not as specified, replace the transmission shift switch assembly.

  2. INSPECT NO. 1 SWITCH WIRE


    1. A01FQ5YE07
      Text in Illustration
      *a

      Front view of wire harness connector

      (No. 1 Switch Wire)

      Connect the No. 1 switch wire connector to the transmission shift switch assembly.

    2. Disconnect the steering pad switch connector from the No. 1 switch wire.

    3. Measure the resistance between each terminal when the transmission shift switch assembly is moved to each position.

      Standard Resistance
      Tester Connection Condition Specified Condition
      A-2 (SFTD) - A-3 (ECC)

      Pull continuously

      "-"

      (Down shift)

      Below 2.5 Ω
      A-1 (SFTU) - A-3 (ECC)

      Pull continuously

      "+"

      (Up shift)

      Below 2.5 Ω
      A-2 (SFTD) - A-3 (ECC)

      Release

      "-"

      (Down shift)

      1 MΩ or higher
      A-1 (SFTU) - A-3 (ECC)

      Release

      "+"

      (Up shift)

      1 MΩ or higher

      If the resistance value is not as specified, replace the No. 1 switch wire.