ПРИВОДНОЙ РЕМЕНЬ УСТАНОВКА


  1. INSTALL FAN AND GENERATOR V BELT

    Tech Tips

    When reusing the fan and generator V belt, check the ribs and back of the fan and generator V belt for wear and cracks. If wear or a crack that reaches the core (at more than 1 point) is found, replace the fan and generator V belt.


    1. A01FSKA

      Partially mount the fan and generator V belt on the engine water pump assembly as shown in the illustration. Mount the fan and generator V belt around the engine water pump assembly partially as shown in the illustration.

      Note


      • Make sure the fan and generator V belt is securely mounted on the crankshaft pulley assembly.

      • Do not allow slack in the fan and generator V belt.

    2. A01FT0S

      While holding the fan and generator V belt on the engine water pump assembly by hand as shown in the illustration, gradually rotate the crankshaft pulley assembly clockwise to mount the fan and generator V belt on the engine water pump assembly.

      CAUTION:

      Do not hold any other parts of the fan and generator V belt, or your fingers may get caught between the fan and generator V belt and engine water pump assembly as they are rotated.

      Note


      • Guide the fan and generator V belt into the grooves of the engine water pump assembly as the crankshaft pulley assembly is rotated.

      • Make sure the fan and generator V belt is not inside out.

    3. A01FVVOE01
      Text in Illustration
      *a Correct
      *b Incorrect

      Rotate the crankshaft pulley assembly until the fan and generator V belt is fully mounted on the engine water pump assembly.

    4. Check that the fan and generator V belt is securely mounted on the crankshaft pulley assembly and engine water pump assembly.

      Note

      Make sure the ribs of the fan and generator V belt are not cracked.

    5. Start the engine and check that the fan and generator V belt turns smoothly without any noise.

  2. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. A01FRJ8E01
      Обозначения на рисунке
      *a Наконечник (круглая часть)

      Установите крышку двигателя № 1 в сборе и введите в зацепление 3 фиксатора в порядке, показанном на рисунке.

      Note


      • Надежно присоедините фиксаторы.

      • Если закреплять фиксаторы с усилием или подвергать их ударам, они могут получить повреждения.

  3. INSTALL NO. 1 AIR CLEANER INLET


    1. Установите входной патрубок воздушного фильтра № 1 и закрепите его болтом.

      Torque:
      5,0 Н*м  { 51 кгс*см, 44 фунт-сила-дюйма }

  4. INSTALL COOL AIR INTAKE DUCT SEAL


    1. Установите сальник впускного воздухопровода холодного воздуха и закрепите его 7 фиксаторами.

  5. INSTALL ENGINE ROOM SIDE COVER


    1. Установите боковую крышку моторного отсека и закрепите ее 4 фиксаторами.