ПРИВОДНОЙ РЕМЕНЬ СНЯТИЕ


  1. REMOVE ENGINE ROOM SIDE COVER


    1. A01FTR0

      Освободите 4 фиксатора и снимите боковую крышку моторного отсека.

  2. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01FS00

      Снимите 7 фиксаторов и сальник впускного воздухопровода холодного воздуха.

  3. REMOVE NO. 1 AIR CLEANER INLET


    1. A01FUV7

      Выверните болт и снимите входной патрубок воздушного фильтра № 1.

  4. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. A01FS2FE01
      Обозначения на рисунке
      *a При отсоединении фиксатора с задней стороны крышки
      A01FVNL Зоны, подлежащие захвату при подъеме крышки двигателя № 1 в сборе

      Поместите обе руки с любой стороны крышки двигателя № 1 в сборе, как показано на рисунке, чтобы отсоединить левый и правый фиксаторы (1 и 2) рядом с передней частью крышки. Затем поднимите крышку, чтобы отсоединить фиксатор (3) с задней стороны, и снимите крышку.

      Note


      • Если левая и правая стороны, а также передняя и задняя стороны крышки будут подниматься одновременно, крышка может быть повреждена.

      • Если не будет в точности соблюдаться порядок выполнения действий, фиксатор с задней стороны крышки может быть поврежден.

      • При попытке снять крышку, открепив только один из передних фиксаторов, крышка может быть повреждена.

  5. REMOVE FAN AND GENERATOR V BELT


    1. Prepare a clean durable piece of cloth and fold it several times.

      Tech Tips

      Fold the cloth several times to make it thicker.

    2. A01FTWJ

      Pass the cloth under the fan and generator V belt between the crankshaft pulley assembly and engine water pump assembly as shown in the illustration.

      Note

      Position the cloth so that the part closest to the engine is longer.

    3. A01FVHU

      Slightly rotate the crankshaft pulley assembly clockwise so that the cloth is pulled between the fan and generator V belt and engine water pump assembly.

      Note

      Do not allow the cloth to be pulled further than the top center of the engine water pump assembly.

    4. A01FR62

      Fold the cloth over the fan and generator V belt and pull it as shown in the illustration while gradually rotating the crankshaft pulley assembly clockwise.

      Note

      Pull the cloth until the upper part of the fan and generator V belt comes off the engine water pump assembly.

    5. A01FRIX

      Check that the upper part of the fan and generator V belt is off the engine water pump assembly, then rotate the crankshaft pulley assembly clockwise to remove the fan and generator V belt.