ПОДОГРЕВАЕМЫЙ КИСЛОРОДНЫЙ ДАТЧИК УСТАНОВКА


  1. INSTALL HEATED OXYGEN SENSOR


    1. A01FSBDE01
      Text in Illustration
      *a Fulcrum Length

      Using SST, install the heated oxygen sensor to the front exhaust pipe assembly.

      SST
      09224-00010
      Torque:
      without SST
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }
      with SST
      40 N*m  { 408 kgf*cm, 30 ft.*lbf }

      Note

      If a heated oxygen sensor has been struck or dropped, replace it.

      Tech Tips


      • Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). When using a torque wrench with a fulcrum length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification.

      • Make sure SST and the wrench are connected in a straight line.

    2. Connect the clamp.

    3. Connect the heated oxygen sensor connector.

  2. INSTALL NO. 2 ENGINE UNDER COVER


    1. Установите защиту картера двигателя № 2 и закрепите ее 4 винтами и 2 уплотнительными шайбами.

  3. INSTALL FRONT SUSPENSION MEMBER BRACE


    1. Установите скобу элемента передней подвески и закрепите ее фиксатором и 4 болтами.

      Torque:
      52 Н*м  { 53 кгс*см, 38 фунт-сила-футов }

  4. INSPECT FOR EXHAUST GAS LEAK

    If gas is leaking, tighten the areas necessary to stop the leak. Replace damaged parts as necessary.

    Tech Tips

    If an exhaust gas leak has been repaired, perform an inspection following the repair.