ДАТЧИК СОСТАВА ТОПЛИВОВОЗДУШНОЙ СМЕСИ УСТАНОВКА

INSTALL AIR FUEL RATIO SENSOR

1. 

   Text in Illustration

   *a	Fulcrum Length

   Using SST, install the air fuel ratio sensor to the exhaust manifold converter sub-assembly.

   SST

   09224-00010

   Torque:

   without SST

   44 N*m  { 449 kgf*cm, 32 ft.*lbf }

   with SST

   40 N*m  { 408 kgf*cm, 30 ft.*lbf }

   Note

   If an air fuel ratio sensor has been struck or dropped, replace it.

   Tech Tips

   
   

   • Use a torque wrench with a fulcrum length of 300 mm (11.8 in.). When using a torque wrench with a fulcrum length that is not 300 mm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification.

   • Make sure SST and the wrench are connected in a straight line.

   • Perform "Inspection After Repair" after replacing an air fuel ratio sensor.

     w/ EGR System: Click here

     w/o EGR System: Click here

2. 

   Text in Illustration

   *1	Wire Harness Clamp Bracket
   *a	Air Hole

   Install the wire harness clamp bracket to the air fuel ratio sensor and connect the clamp.

   Tech Tips

   Make sure that the wire harness clamp bracket does not cover the air holes.

3. Connect the air fuel ratio sensor connector.