ДАТЧИК ПОЛОЖЕНИЯ РАСПРЕДВАЛА УСТАНОВКА


  1. INSTALL VVT SENSOR


    1. for Intake Side:


      1. Apply a light coat of engine oil to the O-ring of the VVT sensor.

      2. Install the VVT sensor to the cylinder head cover sub-assembly with a new bolt.

        Torque:
        10 N*m  { 102 kgf*cm, 7 ft.*lbf }

        Note


        • Make sure that the O-ring is not cracked or moved out of place during installation.

        • If a VVT sensor has been struck or dropped, replace it.

      3. Connect the VVT sensor connector.

    2. for Exhaust Side:


      1. Apply a light coat of engine oil to the O-ring of the VVT sensor.

      2. Install the VVT sensor to the cylinder head cover sub-assembly with a new bolt.

        Torque:
        10 N*m  { 102 kgf*cm, 7 ft.*lbf }

        Note


        • Make sure that the O-ring is not cracked or moved out of place during installation.

        • If a VVT sensor has been struck or dropped, replace it.

      3. Connect the VVT sensor connector.

  2. INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY


    1. A01FRJ8E01
      Обозначения на рисунке
      *a Наконечник (круглая часть)

      Установите крышку двигателя № 1 в сборе и введите в зацепление 3 фиксатора в порядке, показанном на рисунке.

      Note


      • Надежно присоедините фиксаторы.

      • Если закреплять фиксаторы с усилием или подвергать их ударам, они могут получить повреждения.