ДАТЧИК МАССОВОГО РАСХОДА ВОЗДУХА ПРОВЕРКА БЕЗ СНЯТИЯ С АВТОМОБИЛЯ

Note


  • Perform the mass air flow meter sub-assembly inspection according to the following procedure.

  • Only replace the mass air flow meter sub-assembly when the mass air flow meter sub-assembly value in the Data List (with the engine stopped) is not within the normal operating range or there is foreign matter on the mass air flow meter sub-assembly platinum hot wire (heater).


  1. INSPECT MASS AIR FLOW METER SUB-ASSEMBLY

    Tech Tips

    Perform "Inspection After Repair" after replacing the mass air flow meter sub-assembly.



    1. Read the value using the GTS (MAF).

      Note


      • Perform the inspection with the vehicle indoors and on a level surface.

      • Perform the inspection of the mass air flow meter sub-assembly while it is installed to the air cleaner cap sub-assembly (installed to the vehicle).

      • During the test, do not use an exhaust air duct on the exhaust pipe.


      1. Connect the GTS to the DLC3.

      2. Turn the power switch on (IG) (do not start the hybrid system).

      3. Turn the GTS on.

      4. Enter the following menus: Powertrain / Engine and ECT / Data List / MAF.

      5. Wait for 30 seconds, and read the value on the GTS.

        Standard Condition
        Tester Display Condition Specified Condition
        MAF

        • Engine not running

        • 30 seconds after power switch turned on (IG)

        		 0.57 gm/sec or less

        Tech Tips


        • If the result is not as specified, replace the mass air flow meter sub-assembly.

        • If the result is within the specified range, remove and inspect the mass air flow meter sub-assembly Click here.