ДАТЧИК ПОЛОЖЕНИЯ ПЕДАЛИ АКСЕЛЕРАТОРА УСТАНОВКА


  1. INSTALL ACCELERATOR PEDAL SENSOR ASSEMBLY

    Note


    • Avoid excessive force to the accelerator pedal sensor assembly.

    • Do not disassemble the accelerator pedal sensor assembly.

    • This accelerator pedal does not require lubrication.

      Do not apply oil or lubricant to the accelerator pedal sensor assembly.

      If applied, the accelerator pedal sensor assembly must be replaced.


    1. Install the accelerator pedal sensor assembly with the 2 nuts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

    2. Connect the accelerator pedal sensor connector.

  2. INSTALL ACCELERATOR PEDAL


    1. Install the accelerator pedal with the 2 bolts.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

    2. Attach the 2 claws to install the accelerator pedal pad.

  3. INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY


    1. Подсоедините разъемы и зажим.

    2. Установите нижнюю крышку панели приборов № 1 в сборе и закрепите ее 2 захватами.

    3. Вверните 3 винта <A>.