НАСОС СИСТЕМЫ ОХЛАЖДЕНИЯ С ЭЛЕКТРОДВИГАТЕЛЕМ СНЯТИЕ


  1. REMOVE ENGINE ROOM SIDE COVER


    1. A01FTR0

      Освободите 4 фиксатора и снимите боковую крышку моторного отсека.

  2. REMOVE COOL AIR INTAKE DUCT SEAL


    1. A01FS00

      Снимите 7 фиксаторов и сальник впускного воздухопровода холодного воздуха.

  3. REMOVE NO. 1 AIR CLEANER INLET


    1. A01FUV7

      Выверните болт и снимите входной патрубок воздушного фильтра № 1.

  4. REMOVE AIR CLEANER CAP WITH NO. 2 AIR CLEANER HOSE


    1. A01FTMX

      Disconnect the mass air flow meter sub-assembly connector.

    2. Disconnect the wire harness clamp from the air cleaner cap with No. 2 air cleaner hose.

    3. Detach the 4 clamps.

    4. Loosen the hose clamp to remove the air cleaner cap with No. 2 air cleaner hose.

  5. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  6. REMOVE AIR CLEANER CASE SUB-ASSEMBLY


    1. A01FU00E01
      Обозначения на рисунке
      *a Опора воздушного фильтра

      Отсоедините зажим жгута проводов от корпуса воздушного фильтра в сборе.

    2. Выверните 2 болта и снимите корпус воздушного фильтра в сборе.

      Note

      Убедитесь, что опора воздушного фильтра присоединена к кузову.

  7. REMOVE ENGINE UNDER COVER


    1. A01FS2S

      Выверните 13 винтов, расцепите 3 фиксатора и снимите защиту картера двигателя.

  8. DRAIN COOLANT (for Inverter)

    Note


    • Do not reuse the drained coolant because it may contain foreign objects.

    • Collect the drained coolant and measure its volume to establish a benchmark. When adding coolant, make sure to add more coolant than the measured amount.


    1. Remove the reservoir tank cap.

    2. A01FR2J

      Loosen the drain cock plug.

      CAUTION:

      To avoid the danger of being burned, do not remove the reservoir tank cap while the coolant for the inverter is still hot.

  9. REMOVE HV WATER PUMP BRACKET SUB-ASSEMBLY


    1. A01FVW0

      Detach the inverter cooling hose clamp from the inverter water pump with motor assembly.

    2. Slide the 2 clamps and disconnect the hybrid water pump inlet hose and No. 1 hybrid water pump outlet hose from the inverter water pump with motor assembly.

      Note

      Apply insulating tape to the pipe and in the disconnected hose or cover the pipe and hose with plastic bags to prevent entry of foreign matter.

    3. A01FTFH

      Detach the 2 clamps and disconnect the inverter water pump connector.

      Note

      Wipe off any coolant from the connectors of the wire harness and inverter water pump with motor, and apply insulating tape to protect them from coolant.

    4. A01FUSN

      Remove the 2 bolts and HV water pump bracket sub-assembly.

  10. REMOVE INVERTER WATER PUMP WITH MOTOR ASSEMBLY


    1. A01FTF4

      Remove the 3 bolts and inverter water pump with motor assembly from the HV water pump bracket sub-assembly.