FRONT DOOR BELT MOULDING INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips

Use the same procedure for both the RH and LH sides.

PROCEDURE


  1. INSTALL FRONT DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY


    1. A004JBS

      Engage the claws to install the screw and new front door glass outer weatherstrip assembly as shown in the illustration.

  2. INSTALL FRONT DOOR SUSH

    Click here

  3. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

    Click here

  4. INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY

    Click here

  5. ADJUST FRONT DOOR GLASS SUB-ASSEMBLY


    1. Check the front door glass sub-assembly Click here.

    2. Adjust the front door glass sub-assembly Click here.

  6. INSTALL FRONT DOOR SERVICE HOLE COVER

    Click here

  7. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

    Click here

  8. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

    Click here

  9. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  10. INSTALL DOOR ARMREST COVER

    Click here

  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

  12. INITIALIZE POWER WINDOW CONTROL SYSTEM

    Click here

  13. INSPECT POWER WINDOW OPERATION

    Click here