FOG LIGHT ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for both the RH and LH sides.

  • The procedure described below is for the LH side.

PROCEDURE


  1. INSTALL FOG LIGHT ASSEMBLY


    1. Engage the clip to install the fog light assembly.

    2. Install the 2 screws.

      Torque:
      2.0 N*m  { 20 kgf*cm, 18 in.*lbf }

    3. Connect the connector.

  2. INSTALL FRONT FENDER LINER


    1. Install the fender liner with the 3 clips.

    2. Install the bolt.

      Torque:
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

  3. PREPARE VEHICLE FOR FOG LIGHT AIM ADJUSTMENT

    Click here

  4. PREPARE FOR FOG LIGHT AIMING

    Click here

  5. INSPECT FOG LIGHT AIMING

    Click here

  6. ADJUST FOG LIGHT AIMING

    Click here