FRONT SEAT OUTER BELT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    The power window system utilizes a mechanism that the door glass moves down slightly when the door is opened, and that the glass moves up when closing the door in order to prevent the door molding from being damaged. When the battery negative (-) terminal needs to be disconnected for servicing, fully open the driver and passenger door glasses in advance.

  3. REMOVE FRONT DOOR SCUFF PLATE

    Click here

  4. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP


    1. Disconnect the front door opening trim weatherstrip.

  5. REMOVE LUGGAGE COMPARTMENT TRIM COVER

    Click here

  6. REMOVE QUARTER TRIM LID SUB-ASSEMBLY

    Click here

  7. REMOVE REAR WINDOW SIDE GARNISH

    Click here

  8. REMOVE REAR QUARTER TRIM FRONT GARNISH

    Click here

  9. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY


    1. A004HRQE01
      Text in Illustration
      *1 Floor Anchor Cover

      Turn back the floor anchor cover.

    2. Loosen the bolt and disconnect the floor anchor of the front seat outer belt assembly.

  10. REMOVE CENTER PILLAR GARNISH

    Click here

  11. REMOVE FRONT SEAT OUTER BELT ASSEMBLY


    1. A004H3I

      Loosen the bolt and disconnect the shoulder anchor of the front seat outer belt assembly.

    2. A004IAHE01
      Text in Illustration
      *1 Protective Tape
      *2 Pretensioner Connector
      *3 Pretensioner Connector Lock

      Using a screwdriver with the tip wrapped with protective tape, release the pretensioner connector lock and disconnect the pretensioner connector.

      Tech Tips

      Tape the screwdriver tip before use.

    3. A004KBO

      Remove the 2 bolts and disengage the hook to remove the front seat outer belt assembly.