SPIRAL CABLE REMOVAL

PROCEDURE


  1. REMOVE STEERING WHEEL ASSEMBLY

    Click here

  2. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  3. INSPECT SPIRAL CABLE SUB-ASSEMBLY


    1. A004I73

      Check the colored part as shown in the illustration.

      Text in Illustration
      A004HD0 Colored Part

      If the colored part shown in the illustration cannot be confirmed, it is possible that the spiral cable sub-assembly is broken. Replace the spiral cable with sensor sub-assembly with a new one.

  4. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIR BAG ASSEMBLY (w/ Knee Airbag)

    Click here

  5. REMOVE INSTRUMENT SIDE PANEL (w/o Knee Airbag)

    Click here

  6. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)

    Click here

  7. REMOVE INSTRUMENT PANEL ORNAMENT (w/ Large Ornament Panel)

    Click here

  8. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (w/o Large Ornament Panel)

    Click here

  9. REMOVE METER HOOD SUB-ASSEMBLY

    Click here

  10. REMOVE UPPER INSTRUMENT PANEL METER ORNAMENT

    Click here

  11. REMOVE STEERING COLUMN COVER SUPPORT (w/ Entry and Start System)

    Click here

  12. REMOVE LOWER STEERING COLUMN COVER

    Click here

  13. REMOVE UPPER STEERING COLUMN COVER

    Click here

  14. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

    Note


    • Do not replace the spiral cable sub-assembly with the battery connected and the ignition switch ON.

    • Do not rotate the spiral cable sub-assembly without the steering wheel with the battery connected and the ignition switch ON.

    • Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

    3. Check that the front wheels are facing straight ahead.

    4. A004H95E02
      Text in Illustration
      *1 Slider

      Slide the slider to release the lock, and then disconnect the yellow airbag connector from the spiral cable with sensor sub-assembly.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.

    5. Disconnect the other connector from the spiral cable with sensor sub-assembly.

    6. A004KQR

      Disengage the 3 claws to remove the spiral cable with sensor sub-assembly.

  15. REMOVE SPIRAL CABLE SUB-ASSEMBLY

    Note


    • Remove the spiral cable sub-assembly from the steering sensor only when replacing it or the steering sensor.

    • Do not rotate the center section of the steering sensor, as it may deviate from the steering sensor neutral point.


    1. A004H2BE02
      Text in Illustration
      *1 Guide
      *2 Pin

      Disengage the 6 claws, 2 pins and 2 guides to remove the spiral cable sub-assembly from the steering sensor.

      Note

      Do not damage the guide and claw.