STEERING PAD INSTALLATION

PROCEDURE


  1. INSTALL HORN BUTTON ASSEMBLY


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

      Note

      The power window system utilizes a mechanism that the door glass moves down slightly when the door is opened, and that the glass moves up when closing the door in order to prevent the door molding from being damaged. When the battery negative (-) terminal needs to be disconnected for servicing, fully open the driver and passenger door glasses in advance.

    3. for Dual Airbag System


      1. A004KUBE02
        Text in Illustration
        *1 Airbag Connector
        *2 Horn Connector
        *3 Airbag Connector Lock

        Connect the 2 airbag connectors to the horn button assembly.

        Note


        • When connecting any airbag connector, take care not to damage the airbag wire harness.

        • Be sure to only connect the connectors to each corresponding color.

      2. Push in the 2 locks to install the 2 airbag connectors.

      3. Connect the horn connector to the horn button assembly.

    4. for Single Airbag System


      1. A004KXSE02
        Text in Illustration
        *1 Airbag Connector
        *2 Horn Connector
        *3 Airbag Connector Lock

        Connect the airbag connector to the horn button assembly.

        Note

        When connecting any airbag connector, take care not to damage the airbag wire harness.

      2. Push in the lock to install the airbag connector.

      3. Connect the horn connector to the horn button assembly.

    5. A004K8W

      Push the horn button assembly to engage the 3 pins carefully.

      Note


      • Make sure that the pins are securely inserted into the steering holes.

      • Make sure to engage the 2 upper pins first.

      • Make sure that the horn button assembly is securely installed.

  2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

  3. INSPECT HORN BUTTON ASSEMBLY


    1. Make sure that the horn sounds.

      If the horn does not sound, inspect the horn system Click here.

  4. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  5. INSPECT SRS WARNING LIGHT

    Click here