LIGHTING SYSTEM CUSTOMIZE PARAMETERS

PROCEDURE

1. CUSTOMIZE LIGHTING SYSTEM (INT)

   
   

   1. Customizing using the GTS

      Tech Tips

      The following items can be customized.

      Note

      
      

      • When the customer requests a change in a function, first make sure that the function can be customized.

      • Be sure to make a note of the current settings before customizing.

      • When troubleshooting a function, first make sure that the function is set to the default setting.

      
      

      1. Connect the GTS to the DLC3.

      2. Turn the ignition switch to ON.

      3. Turn the GTS on.

      4. Enter the following menus: Customize Setting / Illuminated Entry.

      5. Select the setting by referring to the table below.

         Illuminated Entry

         Tester Display	Default	Content	Setting	Relevant ECU
         Lighting Time	15 s	Changes the lighting time after closing all of the doors. (It will fade out immediately in case of turning the ignition switch from off to ACC or ON.)	7.5 s, 15 s or 30 s	Main body ECU (Network gateway ECU)
         I/L when ACC OFF	ON	Lights up the engine switch illumination*1, ignition key cylinder light*2 and map light when the ignition switch is turned from ACC or ON to off.	ON or OFF
         I/L ON W/Door Key Unlock	ON	Lights up the engine switch illumination*1, ignition key cylinder light*2 and map light when doors are unlocked using a mechanical key or door control transmitter.	ON or OFF
         Room Light when Aprchd*1	ON	Lights up the engine switch illumination and map light when a key enters any actuation area around the doors.	ON or OFF
         Interior Light Control	ON	Lights up the engine switch illumination*1, ignition key cylinder light*2 and map light when the illuminated entry function is operating.	ON or OFF

         
         

         • *1: w/ Entry and Start System

         • *2: w/o Entry and Start System