THEFT DETERRENT SYSTEM CUSTOMIZE PARAMETERS

PROCEDURE

1. CUSTOMIZE THEFT DETERRENT SYSTEM

   Tech Tips

   The following items can be customized.

   Note

   
   

   • When the customer requests a change in a function, first make sure that the function can be customized.

   • Be sure to make a note of the current settings before customizing.

   • When troubleshooting a function, first make sure that the function is set to the default setting.

   
   

   1. Customizing with the GTS

      
      

      1. Connect the GTS to the DLC3.

      2. Turn the engine switch on (IG).

      3. Turn the GTS on.

      4. Enter the following menus: Body Electrical / Main Body / Utility / Customize / Security.

      5. Select the setting by referring to the table below.

         Security

         Display	Default	Content	Setting	Relevant ECU
         Security System	OFF	This function operates the theft deterrent system	ON or OFF	Main Body ECU (Network Gateway ECU)

   2. Theft deterrent system cancel function (manual operation)

      
      

      1. Performing the theft deterrent system cancellation setting allows the theft deterrent system to be stopped.

      2. Configuring the theft deterrent system cancellation setting

         
         

         1. Set the vehicle in the following state.

         
         

         • Disarm the theft deterrent system.

         2. After setting the vehicle in the above state, perform the following operations.

         3. Close all doors and turn the engine switch on (IG).

         4. When the above operations are complete, push down and hold the unlock switch on the door control switch, open the driver side door and hold it for 10 seconds.

         5. When the above operations are complete, the horn sounds twice and "AL OF" appears on the multi-display in the combination meter assembly, informing the operator that the theft deterrent system cancellation setting is complete.

      3. Returning the theft deterrent system from canceled to normal mode.

         
         

         1. Perform the theft deterrent system cancellation setting again.

         2. When the above operations are complete, the horn sounds once and "AL ON" appears on the multi-display in the combination meter assembly, informing the operator that the normal mode setting has been resumed.

            Tech Tips

            
            

            • Each time the cancellation is performed manually, the state changes between canceled and active alternately.

            • When changing from active to canceled state, the horn sounds twice and "AL OF" appears on the multi-display in the combination meter assembly, and when changing from canceled to active state, the horn sounds once and "AL ON" appears on the multi-display in the combination meter assembly, in order to inform the operator of the alarm status.