UNLOCK WARNING SWITCH INSPECTION

PROCEDURE


  1. INSPECT UN-LOCK WARNING SWITCH ASSEMBLY

    A004JB8E07
    Text in Illustration
    *1 Pin
    *a

    Component without harness connected

    (Un-lock Warning Switch Assembly)

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Switch Condition Specified Condition
      1 (UN+) - 2 (UN-) Not pushed 10 kΩ or higher
      Pushed Below 1 Ω

      If the result is not as specified, replace the un-lock warning switch assembly.