READ DATA LIST
Note
In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Tech Tips
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| IG SW | Ignition switch on signal / OFF or ON | OFF: Ignition switch off ON: Ignition switch ON |
- |
| ACC SW | Ignition switch ACC signal / OFF or ON | OFF: Ignition switch off ON: Ignition switch ACC |
- |
| Key Unlock Warning SW | Unlock warning switch / OFF or ON | OFF: Ignition key is not inserted ON: Ignition key is inserted |
- |
| D Door Courtesy SW | Driver side door courtesy light switch signal / ON or OFF | ON: Driver side door opened OFF: Driver side door closed |
- |