STEERING WHEEL INSTALLATION

CAUTION / NOTICE / HINT

Note


  • Do not replace the spiral cable with the battery connected and the ignition switch ON.

  • Do not rotate the spiral cable without the steering wheel with the battery connected and the ignition switch ON.

  • Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.

PROCEDURE


  1. INSTALL NO. 1 STEERING WHEEL ORNAMENT


    1. Engage the 2 claws and guide to install the No. 1 steering wheel ornament.

  2. INSTALL LOWER STEERING WHEEL BOSS COVER (w/ Cruise Control System)

    Click here

  3. INSTALL LOWER STEERING WHEEL BOSS COVER (w/o Cruise Control System)


    1. Engage the 2 claws and install the lower steering wheel boss cover.

    2. Install the 2 screws.

  4. INSTALL STEERING SHAKE DAMPER


    1. Install the steering shake damper with 2 screws to steering wheel assembly.

  5. INSTALL SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY) (for Automatic Transmission)

    Click here

  6. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

  7. INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

    Click here

  8. INSTALL STEERING WHEEL ASSEMBLY


    1. A004J1TE02
      Text in Illustration
      *1 Matchmark

      Install the steering wheel assembly aligning the matchmarks on the steering wheel assembly and steering main shaft.

    2. Install the steering wheel assembly set nut.

      Torque:
      39 N*m  { 398 kgf*cm, 29 ft.*lbf }

    3. Connect the connectors to the spiral cable sub-assembly and steering wheel assembly.

  9. CHECK STEERING WHEEL CENTER POINT

  10. INSTALL HORN BUTTON ASSEMBLY

    Click here

  11. INSPECT HORN BUTTON ASSEMBLY


    1. Make sure that the horn sounds.

      If the horn does not sound, inspect the horn system Click here.

  12. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  13. INSPECT SRS WARNING LIGHT

    Click here