REAR BRAKE FLEXIBLE HOSE INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RH and LH sides.

  • The procedure listed below is for LH side.

PROCEDURE


  1. INSTALL REAR LEFT FLEXIBLE HOSE


    1. Connect the rear left flexible hose with a new clip.

      Note

      Securely install the clip.

    2. Hold the rear left flexible hose with a wrench and connect the brake tube to the rear left flexible hose using a union nut wrench.

      Torque:
      15 N*m  { 155 kgf*cm, 11 ft.*lbf }

      Note


      • Do not bend or damage the brake tube.

      • Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting position.

      • Use the formula to calculate special torque wrench is combined with a torque wrench Click here.

    3. Connect the rear left flexible hose to the rear carrier LH with the bolt.

      Torque:
      33 N*m  { 337 kgf*cm, 24 ft.*lbf }

    4. Connect the rear left flexible hose to the rear disc brake cylinder assembly LH with a new 2 gaskets and the new union bolt.

      Torque:
      18 N*m  { 184 kgf*cm, 13 ft.*lbf }

  2. ADD BRAKE FLUID

    Click here

  3. BLEED BRAKE LINE

    Click here

  4. INSPECT BRAKE FLUID LEAK

  5. INSPECT FLUID LEVEL

    Click here

  6. INSTALL REAR WHEEL

    Torque:
    120 N*m  { 1224 kgf*cm, 88 ft.*lbf }