BRAKE MASTER CYLINDER(for LHD) INSTALLATION

PROCEDURE

1. INSTALL SEAL

   
   

   1. Install a new seal to the brake master cylinder sub-assembly.

2. INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY

   
   

   1. Install the brake master cylinder sub-assembly to the brake booster assembly with the 2 nuts.

      Torque:

      13 N*m  { 133 kgf*cm, 10 ft.*lbf }

   2. Using a union nut wrench 12 mm, install the 2 brake tubes to the brake master cylinder sub-assembly.

      Torque:

      19 N*m  { 194 kgf*cm, 14 ft.*lbf }

      Note

      Use the formula to calculate the special torque values for situations where a union nut wrench is combined with a torque wrench Click here.

   3. Connect the brake fluid level switch connector.

3. BLEED BRAKE SYSTEM

   Click here

4. INSTALL FRONT SUSPENSION UPPER TO COWL BRACE SUB-ASSEMBLY LH

   Click here

5. INSTALL FRONT WHEEL LH

   Torque:

   120 N*m  { 1224 kgf*cm, 86 ft.*lbf }