VSC OFF SWITCH INSPECTION

PROCEDURE


  1. INSPECT PATTERN SELECT SWITCH ASSEMBLY


    1. Make sure that there is no looseness in the locking part and the connecting part of the VSC OFF switch.


      1. A004HRUE01
        Text in Illustration
        *a

        Component without harness connected

        (Pattern Select Switch Assembly)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Check Condition Specified Condition
        5 - 8 Switch not pushed in 10 kΩ or higher
        Switch pushed in Below 1 Ω

    2. Make sure that there is no looseness in the locking part and the connecting part of the TRACK switch.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Check Condition Specified Condition
        1 - 8 Switch not pushed in 10 kΩ or higher
        Switch pushed in Below 1 Ω

    3. Check the illumination status


      1. Check the illumination when the battery voltage is applied between the connector terminals.

        Standard
        Check Condition Specified Condition

        Battery positive → 2

        Battery negative → 3

        		 The illumination comes on