REAR SPEED SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • The procedures listed below are for the LH side.

  • Use the same procedures for the RH and LH sides.

PROCEDURE


  1. INSTALL REAR SPEED SENSOR LH


    1. Install the rear speed sensor LH with the 3 bolts.

      Torque:
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

      Note

      Prevent foreign matter from attaching to the rear speed sensor LH tip, installation surface and sensor body.

    2. Connect the 2 harness clamps.

      Note

      Do not twist the wire harness for the rear speed sensor LH when installing it.

    3. Pull the rear speed sensor LH grommet out from vehicle interior.

      Note


      • Do not pull the rear speed sensor LH wire harness.

      • Do not fix the pass-through grommet at an angle.

    4. Connect the rear speed sensor LH connector.

    5. Install the luggage compartment floor mat.

  2. INSTALL REAR WHEEL LH

    Torque:
    120 N*m  { 1224 kgf*cm, 89 ft.*lbf }

  3. INSPECT SPEED SENSOR SIGNAL

    Click here