REAR BRAKE(for Floating Type Caliper) DISASSEMBLY

CAUTION / NOTICE / HINT

PROCEDURE


  1. REMOVE REAR DISC BRAKE PISTON


    1. A004JVUE03
      Text in Illustration
      *1 Wooden Block
      *a 30 mm (1.1811 in.)

      Place a wooden block between the rear disc brake piston and disc brake cylinder.

    2. Slowly apply compressed air to remove the disc brake piston.

      CAUTION:

      Do not place your fingers in front of the piston when using compressed air.

      Note

      Do not spatter brake fluid.

  2. REMOVE CYLINDER BOOT


    1. A004HUJE01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver with its tip wrapped in protective tape, remove the cylinder boot from the disc brake cylinder.

      Note

      Do not damage the inner surface or groove of the cylinder.

  3. REMOVE PISTON SEAL


    1. A004K7OE02
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver with its tip wrapped in protective tape, remove the piston seal.

      Note

      Do not damage the inner surface or piston seal groove of the cylinder.

  4. REMOVE REAR DISC BRAKE BLEEDER PLUG CAP


    1. Remove the rear disc brake bleeder plug cap from the rear disc brake bleeder plug.

  5. REMOVE REAR DISC BRAKE BLEEDER PLUG


    1. Remove the rear disc brake bleeder plug from the rear disc brake cylinder assembly LH.