BRAKE ACTUATOR REMOVAL

CAUTION / NOTICE / HINT

Note

Before removing the brake actuator assembly, refer to the "Brake line precaution". Click here

PROCEDURE


  1. REMOVE FRONT WHEEL LH

  2. DRAIN BRAKE FLUID

    Note

    Wash off the brake fluid immediately if it comes into contact with a painted surface.

  3. REMOVE FRONT FENDER LINER LH

    Click here

  4. REMOVE BRAKE ACTUATOR ASSEMBLY WITH BRAKE ACTUATOR BRACKET


    1. A004KTN

      Disconnect the harness clamp from the brake actuator bracket.

    2. A004I19

      Disconnect the harness clamp from the brake actuator bracket.

    3. A004HQS

      Disconnect the cooler pipe from the clamp.

    4. A004KHS

      Disconnect the front speed sensor LH harness clamp from the brake actuator bracket.

    5. A004KHNE01
      Text in Illustration
      *a Turn

      Press the wire harness connector locking claw to disengage the locking lever, and turn the locking lever upwards to unlock the connector.

    6. Disconnect the connector from the brake actuator assembly.

    7. A004KP4

      Using a union nut wrench 12 mm, disconnect the 2 brake lines from the brake actuator assembly.

      Note

      Be careful not to allow the brake fluid to enter the removed connector.

    8. A004KF3

      Using a union nut wrench 10 mm, disconnect the 4 brake lines from the brake actuator assembly.

      Note

      Be careful not to allow the brake fluid to enter the removed connector.

    9. A004I4K

      Remove the brake actuator bracket installation bolt.

    10. A004JJ4

      Remove the 3 bolts from the brake actuator with bracket.

    11. Remove the brake actuator with bracket from the vehicle body.

      Note

      Do not damage the brake tubes.