TOE CONTROL LINK INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • The procedure listed below is for the LH side.

  • Use the same procedure for the RH and LH sides.

PROCEDURE


  1. TEMPORARILY INSTALL TOE CONTROL LINK SUB-ASSEMBLY LH


    1. Install the toe control link sub-assembly LH and insert the toe adjust cam from the front of the vehicle. Then, install the rear No. 2 suspension toe adjust plate and temporarily install the new nut.

      Note

      Align the matchmarks on the rear suspension member and the rear No. 2 suspension toe adjust plate.

    2. Install the rear suspension toe control link sub-assembly LH to the rear axle carrier side with a nut.

      Torque:
      60 N*m  { 612 kgf*cm, 44 ft.*lbf }

    3. Install the new snap pin.

  2. TEMPORARILY INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY LH

    Click here

  3. STABILIZE SUSPENSION

    Click here

  4. FULLY TIGHTEN TOE CONTROL LINK SUB-ASSEMBLY LH


    1. Fully tighten the nut on the rear suspension member side.

      Torque:
      100 N*m  { 1020 kgf*cm, 74 ft.*lbf }

      Note

      Check that the matchmarks on the rear suspension member and the rear No. 2 suspension toe adjust plate are aligned.

  5. FULLY TIGHTEN REAR NO. 1 SUSPENSION ARM ASSEMBLY LH

    Click here

  6. INSTALL REAR WHEEL

    Torque:
    120 N*m  { 1224 kgf*cm, 89 ft.*lbf }

  7. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

    Click here

  8. VSC SENSOR NEUTRAL MEMORIZATION

    Click here