REAR LOWER ARM INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • The procedure listed below is for the LH side.

  • Use the same procedure for the RH and LH sides.

PROCEDURE


  1. TEMPORARILY INSTALL REAR NO. 2 SUSPENSION ARM ASSEMBLY LH


    1. Temporarily install the rear No. 2 suspension arm assembly to the rear suspension member with the bolt and new nut.

      Note

      Insert the bolt from the front side of the vehicle.

    2. Temporarily install the rear No. 2 suspension arm assembly to the axle carrier with the bolt and new nut.

      Note

      Insert the bolt from the front side of the vehicle.

  2. TEMPORARILY INSTALL REAR SHOCK ABSORBER WITH COIL SPRING


    1. Temporarily install the rear shock absorber with coil spring to the rear No. 2 suspension arm assembly LH with the bolt and new nut.

      Tech Tips

      The bolt may be inserted from either direction.

  3. INSTALL STABILIZER LINK SUB-ASSEMBLY (for LH Side)

    Click here

  4. INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY LH (w/ HID Headlight System)

    Click here

  5. TEMPORARILY INSTALL REAR NO. 1 SUSPENSION ARM ASSEMBLY LH


    1. Temporarily install the rear No. 1 suspension arm assembly LH to the axle carrier with the new bolt and new nut.

      Note

      Insert the bolt from inside the vehicle.

    2. Temporarily install the rear No. 1 suspension arm assembly LH to the rear suspension member with the new bolt and new nut.

      Note

      Insert the bolt from outside the vehicle.

  6. STABILIZE SUSPENSION

    Click here

  7. FULLY TIGHTEN REAR NO. 2 SUSPENSION ARM ASSEMBLY LH

    Click here

  8. FULLY TIGHTEN REAR NO. 1 SUSPENSION ARM ASSEMBLY LH


    1. Fully tighten the 2 bolt and 2 nut of the rear No. 1 suspension arm assembly LH.

      Torque:
      110 N*m  { 1122 kgf*cm, 81 ft.*lbf }

  9. INSTALL NO. 1 PARKING BRAKE CABLE SUPPORT BRACKET


    1. Install the No. 1 parking brake cable support bracket with the bolt.

      Torque:
      18 N*m  { 184 kgf*cm, 13 ft.*lbf }

  10. INSTALL REAR WHEEL

    Torque:
    120 N*m  { 1224 kgf*cm, 89 ft.*lbf }

  11. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

    Click here

  12. VSC SENSOR NEUTRAL MEMORIZATION

    Click here

  13. HEIGHT CONTROL SENSOR SIGNAL INITIALIZE (w/ HID Headlight System)

    Click here

  14. ADJUST HEADLIGHT AIMING (w/ HID Headlight System)

    Click here